فیلم آموزش نرم افزار اینفراورکس InfraWorks Watershed and rainfall content settings
در ویدیوی گذشته ما یک حوضه جاده ای برای مسیری که ما طراحی کرده ایم ایجاد می کنیم. ما قصد داریم به برخی از مقادیری که ما می توانیم برای تجزیه و تحلیل حوضه حتی بعد از حوضه ایجاد شده، نگاه کنیم. در حال حاضر ما حوزه خود را در حال حاضر کشیده شده است. این یک آبشار در InfraWorks است. بنابراین، اگر من آن را انتخاب کنید من کارت دارایی حوزه آب. این در سمت راست نشان داده می شود. ما می توانیم رنگ این حوضه را تغییر دهیم به خصوص اگر در مدل InfraWorks ما دارای اشیاء آبشار چندگانه باشیم. ما ممکن است بخواهیم این سبک را برای حوضه های مختلف تغییر دهیم. اما عامل اصلی در اینجا، برخی از کنترل هایی است که ما برای داده های هیدرولوژی ما داریم. به عنوان مثال، ما می توانیم انتخاب کنیم که کدام روش را استفاده کنیم. بنابراین، ما قصد داریم به عنوان روش ما منطقی را تنظیم کنیم، به همین دلیل ما در حال حاضر ارزش های مختلفی را در اختیار ما قرار می دهیم. بنابراین بگذارید ضریب ما را به چیزی تقریبا مثل نقطه چهارم بگذاریم و میزان بارش 100 ساله ما سه اینچ در ساعت باشد.
Now we can continue to make adjustments to this but notice as I make those adjustments for the 100 year our CSF values continue to adjust as well. So, we have all of this control within our watershed model. One of the key factors is also where is it getting that rainfall data from? So we're going to go back to our design, review, and engineer drainage category and in the analyze model subsection notice one of the functionalities or features here is rainfall content. Let's go ahead and select this and the rainfall content opens up a panal and allows us to have different IDF models or we can use different means. It doesn't have to be an IDF curve. Notice one of them uses BDE as a means to do so and there's other methods as well that we can input. So we can go ahead and select the tabular sample here and we can create a new one that's completely empty or as we did with most of the styles we copied. And we're going to create a copy here and we're going to name this LinkedIn. Now we have a copy of that model of a rainfall content. We're going to open that up and notice that we have a nice curve here that can be set up and each one of these values for our intensities depending on the type of storm that we're working with are editable. So we can set all of these values to our specific projects values or needs for the rainfall content and then make sure that we select the correct rainfall content for our model. We're going to have a lot of different controls here and ultimately when we establish our watershed and the rainfall content that is being used then we have a lot more control over this sizing that the software automatically sets for our culverts as well as any other drainage network functions that we have built in